Smeg CMSC45NE Manuel télécharger pdf (Page 12)

9. "HOT WATER PRESS OK" is displayed.

10. Press the OK button (B9)

The appliance begins delivering hot water

and the message "PLEASE WAIT... " is di-

splayed.

After the flow of hot water stops, the ap-

pliance automatically resets to "READY" sta-

tus.

Replacing the filter ("Filter

Reset")

When "REPLACE FILTER" is displayed or after 2

months of use (see date indicator), the filter must

be replaced:

1. Remove the exhausted filter;

2. Remove the new filter from the packaging.

3. Slide the pointer of the date indicator (see fig.

28) until the months of use are displayed (the

filter lasts about 2 months).

4. Insert the filter in the water tank and press it

until it touches the bottom of the tank (see

fig. 28).

5. Fill the water tank and insert in the coffee

maker;

6. Turn the cappuccino maker outwards and

place a container underneath (min. capacity

100 ml).

7. Press the MENU button (B6) to enter the

menu;

8. Press the NEXT button (B7) until "FILTER

RESET NO" is displayed.

9. Press the CHANGE button (B8) until "FILTER

RESET YES" is displayed.

10. Press the OK button (B9) to confirm.

11. "HOT WATER PRESS OK" is displayed.

12. Press the OK button (B9) again. The ap-

pliance begins delivering hot water and the

message "PLEASE WAIT... " is displayed.

After the flow of hot water stops, the ap-

pliance automatically resets to "READY" sta-

tus.

Removing the filter

If you want to use the appliance without a filter,

you must remove it and notify the appliance of

its removal as follows:

1. Press the MENU button (B6) to enter the menu.

2. Press the NEXT button (B7) until "UNINSTALL

FILTER" is displayed.

3. Press the OK button (B9). The appliance auto-

matically resets to "READY" status.

TURNING ON AND HEATING

Each time the appliance is turned on, it performs

an automatic preheat and rinse cycle which can-

not be interrupted.

The appliance is ready for use only after comple-

tion of this cycle.

Danger of burns!

During rinsing, a little

hot water flows from the coffee spouts.

Avoid contact with splashes of water.

To turn the appliance on, turn the knob (A7)

(to the right or left) (fig. 5). "HEATING UP...

PLEASE WAIT" is displayed.

After heating, the message "RINSING" is displa-

yed. As well as heating the boiler, the appliance

also heats the internal circuits by circulating hot

water.

The appliance is at temperature when the mes-

sage "READY STANDARD TASTE" is displayed.

MAKING COFFEE USING

COFFEE BEANS

1. The appliance is preset to make coffee with a

standard taste. You can also choose coffee

with an extra-light, light, strong or extra-

strong taste.

To choose the required taste, press the

button (B2) (fig. 6). The required coffee taste

is displayed.

2. Place 1 cup under the spouts to make 1 cof-

fee (fig. 7) or 2 cups for 2 coffees (fig. 8).

Lower the spouts as near as possible to the

cup for a creamier coffee (fig. 9).

3. Press the button (B3) to make a short

coffee (fig. 10), the button (B4) for a

standard coffee and the button (B5) for

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 26 27

Commentaires sur ces manuels

Pas de commentaire

Smeg CMSC45NE Manuel Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Cafetières Smeg CMSC45NE