Smeg CMSC45NE Manuel télécharger pdf (Page 14)

Important!

when removing the drip tray,

the grounds container must be emptied, even if it

is not completely full. If this is not done, when

you make the next coffees, the grounds container

may fill up more than expected and clog the ma-

chine.

NOTE 8: Never extract the water tank while the

machine is delivering coffee.

If it is removed, it will not be possible to make

the coffee and the appliance will display

"GROUND TOO FINE ADJUST MILL AND PRESS

OK". To use the appliance again, replace the water

tank, press the OK button (B9). "HOT WATER

PRESS OK" is displayed. Press the OK button

(B9) and deliver water from the cappuccino

maker for a few seconds.

CHANGING THE QUANTITY

OF COFFEE IN THE CUP

The appliance is set by default to automatically

make the following types of coffee:

• Short coffee when the button (B3) is

pressed.

• Standard coffee when the button (B4) is

pressed.

• Long coffee when the button (B5) is

pressed. To change these quantities, proceed

as follows:

• Press the button corresponding to the quan-

tity you want to change ( , or ) for

at least 10 seconds then release until the

message "PROGRAM QUANTITY" is displa-

yed and coffee delivery commences.

• When the coffee in the cup reaches the re-

quired level, press the same button again to

memorise the new amount.

The appliance is now reprogrammed with the

new settings and displays: "READY".

ADJUSTING THE COFFEE

MILL

The coffee mill is preset in the factory to make

coffee correctly and should not require adjusting

initially.

However, if after making the first few coffees you

find that delivery is either too fast or too slow (a

drop at a time), this can be corrected by adjusting

the grinding adjustment knob (fig. A17) (fig. 11).

Important!

The grinding adjustment knob

must only be turned when the coffee mill is in

operation.

For slower delivery and

creamier coffee, turn one

click anticlockwise (finer

pre-ground coffee).

For faster delivery (not a

drop at a time), turn one

click clockwise (coarser

pre-ground coffee).

(Coffee has been used to

factory test the appliance

and it is therefore completely normal for there to

be traces of coffee in the mill.

It is, however, guaranteed to be new.)

MAKING ESPRESSO

COFFEE WITH PRE-

GROUND COFFEE (INSTEAD

OF BEANS)

• Press the button (B7) (fig. 15) to se-

lect the pre-ground coffee function. This di-

sables the coffee mill function.

The appliance now displays the message:

"READY PRE-GROUND".

• Extract the machine by pulling it outwards

using the handles.

• Lift the central lid, place one measure of pre-

ground coffee in the funnel (fig. 16), push the

appliance in then proceed as described in the

chapter "Making coffee using coffee beans".

N.B.: You can make just one coffee at a time

by pressing the (B3), (B4) or (B5)

button once only.

• After using the machine with pre-ground cof-

fee, to go back to making coffee using beans,

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 26 27

Commentaires sur ces manuels

Pas de commentaire

Smeg CMSC45NE Manuel Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Cafetières Smeg CMSC45NE