Smeg CMSC45NE Manuel Page 18

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 27
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 17
19
7. Once inserted, make
sure the two red but-
tons have snapped out.
8. Replace the drip tray
(A14) and grounds con-
tainer.
9. Close the service door
(A2).
CHANGING AND SETTING
MENU PARAMETERS
After turning the knob (A7) and waiting for
the appliance to be ready, you can use the inter-
nal menu to modify the following parameters and
functions:
CLOCK
START TIME7:30
AUTO-START NO
DESCALE NO
TEMPERATURE MEDIUM
OFF AFTER 1 HOUR
WATER HARDNESS 4
DEFAULT VALUES NO
INSTALL/UNINSTALL FILTER
FILTER RESET NO
INSTALL FILTER/UNINSTALL FILTER (*)
• FILTER RESET
(*)
(certain models only)
Setting the clock
To set the clock, proceed as follows:
Press the MENU button (B6) then press the
NEXT button (B7) repeatedly until the ap-
pliance displays: "CLOCK… 00:00"
Press the CHANGE button (B8) to set the
clock.
(If you hold the CHANGE button down, the
time is changed rapidly).
Press the OK button (B9) to confirm.
Press the MENU button to exit programming
mode or NEXT to change other parameters.
If auto-start is set, when the appliance is in
stand-by, press any button to display the
auto-start symbol for 5 seconds.
Setting auto-start time
This function programmes the time the machine
will come on automatically to be ready for use.
Make sure the clock on the appliance is set as
described in the previous chapter.
Press the MENU button (B6) (the light over
the button comes on) then press the NEXT
button (B7) repeatedly until the appliance di-
splays: "START TIME… 00:00".
Press the CHANGE button (B8) to set the
auto-start time.
(If you hold the CHANGE button down, the
time is changed rapidly).
Press the OK button (B9) to confirm.
Press NEXT once and the appliance displays
the message: "AUTO-START NO".
Press the CHANGE button to modify the fun-
ction (the machine displays "AUTO-START
YES" ).
Press the OK button to activate auto-start;
NOTE: when the machine is off and an auto-
start time has been set, the symbol ap-
pears alongside the time on the unlit display.
Press the MENU button to exit programming
mode or NEXT to change other parameters.
Descaling
Important!
Before descaling, make sure
the water softener filter (if present) has been re-
moved.
Important!
Descaler contains acids which
may irritate the skin and eyes.
It is vital to respect the manufacturer’s safety
warnings given on the descaler pack and the war-
nings relating to the procedure to follow in the
event of contact with the skin and eyes.
N.B.!
Use the descaler recommended by
the manufacturer only.
Vue de la page 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Commentaires sur ces manuels

Pas de commentaire