Smeg SCM1-1 Manuel de service Page 30

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 108
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 29
30
4 - USO
I
4.5 Introdurre l’acqua
Può avvenire in due modi: da contenitore o dalla rete idrica.
Da contenitore:
Estrarre la macchina dal suo alloggio.
Controllare che l’interruttore 14 per la selezione della fonte idrica sia
posizionato sul simbolo del contenitore.
Scollegare il tubicino del tappo
T tirandolo verso l’alto.
Estrarre il contenitore 15 e svitare il tappo
T.
Riempire il contenitore con acqua fresca potabile e riavvitare il tappo.
Reinserire il contenitore nel suo alloggio.
Ricollegare il tubicino al tappo
T premendono in fondo.
Reinserire la macchina nel suo alloggio.
NB: è normale che nel contenitore rimanga una certa quantità d’acqua,
anche se la macchina segnala la sua mancanza.
Da rete idrica:
Estrarre la macchina dal suo alloggio.
Controllare che l’interruttore 14 per la selezione della fonte idrica sia po
-
sizionato sul simbolo del rubinetto (in caso di installazione di un rubinetto
a monte dell’elettrovalvola di ingresso acqua 16, accertarsi che questo
sia aperto).
Reinserire la macchina nel suo alloggio.
NB: è normale che nel contenitore rimanga una certa quantità d’acqua,
anche se la macchina segnala la sua mancanza.
G
R
O
S
S
O
F
I
N
E
BER-146
15
T
14
G
R
O
S
S
O
F
I
N
E
BER-146
14
16
4 - USE
GB
16 17
4.5 Adding water
This can be done in two different ways: either from the container or
from the water mains supply.
From the container:
Remove the machine from its housing.
Check that switch
14 to select the water source is pointing to the container
symbol.
Pull the little tube of cap
T upwards in order to disconnect it.
Remove container
15 and unscrew cap T.
Fill the container with fresh drinking water and screw the cap back on.
Replace the container into position.
Reconnect the little tube to cap
T and push it down as far as it will go.
Replace the machine into position.
NB: a certain amount of water will always remain in the container even when
the message appears to say that the container is empty.
From the water mains supply:
Remove the machine from its housing.
Check that the switch
14 to select the water source is pointing to the tap
symbol (if a tap has been installed above the water inlet solenoid valve
16, make sure this is open).
Replace the machine into position.
NB: a certain amount of water will always remain in the container even when
the message appears to say that the container is empty.
Vue de la page 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 107 108

Commentaires sur ces manuels

Pas de commentaire