Smeg SCM1-1 Manuel de service Page 80

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 108
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 79
80
6 - MANUTENZIONE
I
6 - MANTENANCE
GB
CB1607-260
F
CB1607-270
CB1607-280
2
6.5 Sostituzione della guarnizione portafiltro
Accedere nella parte interna della macchina, come descritto nel paragrafo
“APERTURA SUPERIORE”.
Localizzare il portafiltro
F. (Fig.35)
Rimuovere la guarnizione OR portafiltro danneggiata aiutandosi, se
necessario, con un cacciavite a lama piatta.
Pulire la sede della guarnizione con il pennellino
2.
Posizionare la nuova guarnizione, senza usare alcun utensile.
6.6 Sostituzione della lampada
Controllare che l’interruttore generale della macchina sia spento.
Scollegare la macchina dalla presa di corrente.
Svitare la plafoniera della lampada nel punto indicato in figura 36 (a destra
del beccuccio erogazione caffè).
Svitare la lampadina e sostituirla con una nuova e della stessa tipologia
(2W).
Riposizionare la plafoniera.
ATTENZIONE! Superfici calde.
Alcune parti della macchina, possono trovarsi ad una tem
-
peratura molto alta e provocare ustioni! Accertarsi che la
macchina sia fredda.
IMPORTANTE!
QUESTA OPERAZIONE DEVE ESSERE ESEGUITA OGNI 6
MESI
SG-065
35 36
6.5 How to replace the filter holder gasket
For access inside the machine, follow the instructions in paragr. “HOW
TO OPEN THE TOP OF THE MACHINE”.
Find the lter holder
F. (Fig.35)
If necessary, use a flat-bladed screw driver to remove the filter holder OR
gasket.
Clean the gasket slot with the brush
2.
Put a new gasket into position without the aid of any tool.
6.6 How to replace the light bulb
Check that the main switch of the machine is switched off.
Disconnect the machine from the mains plug.
Unscrew the lamp cover at the point shown in the picture 36 (to the right
of the coffee spout).
Unscrew the light bulb and replace it with a new one of the same type
(2W).
Replace the cover into position.
WARNING! Hot surfaces.
Some parts of the machine become extremely hot and can
burn! Make sure the machine has cooled down.
IMPORTANT!
THIS OPERATION MUST BE PERFORMED EVERY 6
MONTHS
Vue de la page 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 107 108

Commentaires sur ces manuels

Pas de commentaire