Smeg SR60GHU3 Manuel d'instructions télécharger pdf (Page 5)

Instructions for the User

3. USING THE COOKTOP

WARNING

FIRE HAZARD

FOR YOUR SAFETY:

- Do not allow the burner flame to extend beyond the

edge of the pan.

- Turn off all controls when not cooking.

NOTE: Check that the flame caps have been correctly installed on the flame

diffuser rings. If it is an ultra rapid burner, make sure that the notches A are

centered correctly with the pins B.

3.1 Ignition with safety device

Each knob has a symbol that shows the corresponding burner (the example on the left shows the front

left burner).

The appliance is equipped with an electronic ignition.

- Just press and simultaneously turn the knob counter-clockwise to the minimum flame symbol until

the burner switches on.

- Keep the knob pressed down for about 2 seconds to keep the flame lit and to activate the safety

device.

- After switching the burner on it is recommended that the knob be left in the minimum position for

approximately 20 seconds before adjusting it to the desired temperature.

The flame may go out when the knob is released. In this case repeat the operation, but keeping the

knob pressed down for a longer period of time.

NOTE: If the flame goes out accidentally, after about 20 seconds the safety device will intervene and

block the gas flow, even when the valve is open.

REMEMBER: When the cooktop is in use, the entire cooktop area may become hot

1 2 3 4 5 6 7 8 9

Pas de commentaire

Smeg SR60GHU3 Manuel d'instructions Page 5