Smeg SUK92MFX5 Manuel de service télécharger pdf (Page 5)

Instructions for the user

7. USE OF THE HOB

7.1 Lighting of the hob burners

Before lighting the hob burners check that the flame caps are in the correct position and that their burner

caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and

thermocouples.

The optional grid B is for use with “woks” (Chinese pans).

To prevent deterioration of the hob we have equipped the cooker with a raised pan stand C to be placed

underneath pans more than 26 cm in diameter.

The supplied reduction rest C is used also for small pans.

The drawing next to each knob shows the corresponding burner. The appliance

has an electronic lighting device. Simply press and turn the knob anticlockwise

to the minimum flame symbol , , until the flame is lit. Hold the knob down for a

few seconds to allow the thermocouples to heat up. The burner may go out

when the knob is released: this is because the thermocouple has not been

sufficiently heated. Repeat the operation holding down the knob a little longer.

This operation is not necessary for burners without thermocouples.

For models with thermocouples, should the burner accidentally go out, a safety device will be activated

which stops the gas flow even if the tap is open.

7.2 Practical advice for using the hob burners

For better use of the burners and lower gas consumption, use covered vessel that are proportional in

size to the burner to prevent the flame from licking the sides (see paragraph “ 7.3 Diameter of the

vessels to be used on each burner”). When water reaches the boiling point, lower the flame so that it

doesn’t overflow. To avoid burns or damage to the hob, all vessels or griddle plates must be placed

within the perimeter of the hob. All vessels must have a flat and smooth bottom. When using fats or oils,

be extremely careful that they don’t overheat and catch fire.

If the flame accidentally goes out, turn off the control knob and wait at least 1 minute before trying to re-

light the burner.

7.3 Diameter of the vessels to be used on each burner

BURNERS

1. Auxiliary

2. Semirapid

3. Rapid

4. Triple Crown

Ø MIN. AND MAX. (IN

CM.)

12 - 14

16 - 24

18 - 26

1 2 3 4 5 6 7 8 9 10 ... 19 20

Pas de commentaire

Smeg SUK92MFX5 Manuel de service Page 5