Smeg SFR30 Manuel d'utilisateur télécharger pdf (Page 3)

1) SWITCHING ON THE FRYER

The fryer is controlled by a thermostat and it can be

switched on by turning the knob clockwise to the

position desired (see fig. 1). A red indicator lamp

indicates it is switched on.

Automatic cut-off switch

The appliance is provided with a cut-off device which

intervenes if the oil temperature exceeds the safety

limit. This device stops the fryer from functioning. For

the fryer to start functioning again, you must wait until

the oil temperature drops; then release the cut-off

switch manually to start the appliance again.

To carry out this procedure follow the instructions

below:

· lift up the resistance and secure it in the vertical

position;

· remove the kettle containing the oil taking care not

to burn yourself;

· unscrew the tap situated in the rear of the interior

casing (fig. 2);

· push the red button (fig. 3).

If the red button does not release, it means that the

temperature sensor of the shut-down thermostat has

not cooled down sufficiently. Wait for a few minutes

then try again. If the problem persists even when the

appliance is cool contact your nearest service centre.

USE

FIG. 1 FIG. 2 FIG. 3

1 2 3 4 5 6 7 8 ... 11 12

Pas de commentaire

Smeg SFR30 Manuel d'utilisateur Page 3