Smeg LS6147XH7 Manuel d'utilisateur télécharger pdf (Page 13)

User instructions

FAULT DESCRIPTION

Turbine flow-regulator malfunction

The appliance is not able to "measure" the

amount of water loaded accurately. Interrupt

the program and switch off the dishwasher.

Switch the dishwasher back on, program it

again and start the washing cycle. If the

problem persists, contact the after-sales

service.

Alternate washing system malfunction

Interrupt the program and switch off the

dishwasher. Switch the dishwasher back on,

program it again and start the washing cycle. If

the problem persists, contact the after-sales

service.

Water intake system malfunction

Contact the after-sales service.

Light off Light on Light flashing

If an alarm occurs the appliance interrupts the program in progress and

signals a fault.

•

Alarms

E1, E2, E3, E4, E8

and

interrupt the current program

immediately.

•

The

alarms interrupts the running program once the cause is

resolved, it will bring bach the execution of the program.

•

The alarm

is visualized at the end of the cycle that comes, however,

brought to the end since the operation of the dishwasher is not harmed.

To “reset” an alarm is necessary:

•

Open and close the door, or turn off and on the machine. At this point is

possible to program the dishwasher again.

If the malfunction persists, contact your authorised Service Centre.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Pas de commentaire

Smeg LS6147XH7 Manuel d'utilisateur Page 13