Smeg LSA6445B2 Manuel d'instructions

INSTRUCTION MANUAL GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS

User instructions 8 NOTES AND REFERENCES Only run the soak program with half loads. Options cannot be used with the soak progr

User instructions 9 1.2 Washing programs The dishwasher is equipped with a control panel, described in chapter "3. Description of the

User instructions 10 STARTING THE PROGRAM To start the dishwasher, press the START/PAUSE button (3) for a few seconds, until the light of the

User instructions 11 CHANGING A PROGRAM To change the running program it is necessary: • to interrupt the running program (see “INTERRU

User instructions 12 "Flexi Tabs" The option is optimised for use of detergents which are complete with salt and rinse aid. Wit

User instructions 13 PROGRAM DELAY The PROGRAM DELAY button can be pressed to delay the start of the washing program by from 1 to 12/24 h

User instructions 14 ENERGY MANAGEMENT After 5 minutes of waiting (washing cycle completed, stopped or set but not started) the dishwasher

User instructions 15 2. Operating instructions Once the dishwasher has been correctly installed, prepare for use as follow

User instructions 16 • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening sys

User instructions 17 WATER HARDNESS TABLE WATER HARDNESS SETTING German degrees (°dH) French Degrees (°dF) 0 - 4 0 - 7 H 0 - NO SALT 5 - 15 8

User instructions 18 ADDING THE RINSE AID The rinse aid helps the dishes dry faster and prevents the formation of scale deposits

User instructions 19 ADDING THE DETERGENT To open the detergent dispenser cap, lightly press the button P. Add the detergent and

User instructions 20 The introduction of detergent into the rinse aid dispenser, even in liquid form, will damage the dishwasher.

User instructions 21 WARNING! • Make sure that the dishes are securely in place so that they cannot tip over or obstruct the

User instructions 22 2.4 Using the baskets The dishwasher has a capacity of 13 place-settings, including serving dishes. LOWER BASKET The l

User instructions 23 LOADING THE LOWER BASKET Carefully load flat plates, soup plates, dessert and serving dishes, positioning them ve

User instructions 24 CUTLERY BASKET The basket has removable top grids into which items of cutlery should be inserted to keep them properly

User instructions 25 UPPER BASKET It is recommended to load the upper basket with small- or medium-sized items such as glasses, small plates, t

User instructions 26 Depending on the models, the basket may be equipped with some or all of the following accessories: - Supports for cups or l

User instructions 27 ADJUSTING THE UPPER BASKET The height of the top basket can be adjusted to allow large dishes or pans to be p

Contents 1 1. Description of the controls ________________________________ 2 2. Operating instructions ___________________________________ 15

User instructions 28 3. Cleaning and maintenance Before carrying out any work, always unplug the appliance from the electrical supply or switc

User instructions 29 CLEANING THE FILTER UNIT • It is advisable to periodically inspect the centre filter C and, if necessary, t

User instructions 30 BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE: • Check that there are no deposits of sludge or rust insid

User instructions 31 If the dishes fail to dry or remain dull, check that: • there is rinse aid inside the special container; • the rinse

User instructions 32 4. Troubleshooting The dishwasher is equipped with a self-diagnostics system that is capable of detecting and signalling

User instructions 33 TECHNICAL DATA Width 597 ÷ 599 mm Depth measured flush with the outer edge of the control panel Free standing: 600 mm Se

User instructions 2 1. Description of the controls 1.1 Front panel The ON/OFF is on the top edge of the panel, and all the dishwasher’s o

User instructions 3 1 ON/OFF BUTTON 2 SELECTION PROGRAMS BUTTON 3 START/PAUSE BUTTON 4 PROGRAMS LIGHTS 5 PHASES/PROGRAM LIGHTS + PROGRA

User instructions 4 <<OPTIONS(8)>> Depending on the model, this zone may contain one or more of the following options

User instructions 5 PROGRAMS TABLE PROGRAMME NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION

User instructions 6 PROGRAMS TABLE PROGRAMME NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MIN

User instructions 7 PROGRAMS TABLE PROGRAMME NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS DURATION CONSUMPTION MI