Smeg ST8246U Manuel télécharger pdf (Page 15)

USER INSTRUCTIONS

f fo gnihct iwS 8.2.2

eh t dna peeb t r ohs a s t ime r ehsawhs i d eh t ,ma r go r p eh t f o dne eh t t A indi-

cator lights of the fourth and ﬁ fth program (ref. pr. 4, pr. 5 ﬁ g. 2-04) ﬂ ash.

Turn off the appliance by opening the door and pressing the on/off button (ref.

1 ﬁ g. 2-02).

FIG. 2-04

If it is necessary to open the door during the washing cycle, the

program will be interrupted, the relative indicator light will continue to

ﬂ ash and a beep will indicate that the cycle has not terminated. Wait

for about 1 minute before closing the door and continuing with the

program. When the door closes, the program will start from where it

was interrupted. This operation should be performed only if neces-

sary as it could cause irregular program performance.

SEHS I D EHT G N I V OME R 4

˜˜˜

t sae l t a t i aw ,m a r go r p gn i hsaw eh t f o dne eh t t A 20 minute before

removing the dishes in order to allow them to cool. To prevent any

water droplets on the upper rack from falling onto the dishes in the

lower rack, empty the lower rack ﬁ rst and then the upper one.

2.2.9

symbols programs according to the models

2.3 Additional functions

2.3.1 Adjusting the water softener (on some models only)

N.B.: a different washing program from soak must be used to make

the following adjustment.

Press and hold down the program delay button (ref. 12 ﬁ g. 2-05) until the

preset value appears followed by a dot (normally 3.). Release the button and

then press it again and again until the required value is displayed, as indicated

in the table (see tab. 2-03).

The 6 possible adjustment levels will appear in this sequence:

3., 4., 5., 0., 1., 2..

When the required value appears on the display, release the button; after 5

seconds the appliance automatically reverts to the program delay and the

adjustment is set to the chosen value.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 49 50

Pas de commentaire

Smeg ST8246U Manuel Page 15