Smeg ST8246U Manuel Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 50
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
18
USER INSTRUCTIONS
EN
EN
16
USER INSTRUCTION
5 OPERATING INSTRUCTIONS
BEFORE STARTING TO USE THE APPLIANCE, MAKE SURE YOU HAVE
READ AND UNDERSTOOD ALL THE WARNINGS CONTAINED IN CHAP-
TER 2 “IMPORTANT SAFETY INSTRUCTION”.
Once the dishwasher has been correctly installed, prepare for use as follows:
add the rinse-aid and detergent.
5.2 Using the rinse-aid and detergent dispensers
The detergent and rinse aid dispensers are situated on the inner part of the door:
the detergent dispenser (ref. A fig. 5-03) is on the left, and the rinse-aid
dispenser (ref. B fig. 5-03) is on the right.
A
B
WITH THE EXCEPTION OF THE SOAK PROGRAM, BEFORE EVERY
WASHING CYCLE IT IS NECESSARY TO ADD THE REQUIRED AMOUNT
OF DETERGENT TO THE DETERGENT DISPENSER. THE RINSE AID,
ON THE OTHER HAND, SHOULD ONLY BE ADDED AS REQUIRED.
Fig. 5-03
adjust the water softening system;
add the regenerating salt;
EN
20
USER INSTRUCTION
5 OPERATING INSTRUCTIONS
BEFORE STARTING TO USE THE APPLIANCE, MAKE SURE YOU HAVE
READ AND UNDERSTOOD ALL THE WARNINGS CONTAINED IN CHAP-
TER 2 “IMPORTANT SAFETY INSTRUCTION”.
Once the dishwasher has been correctly installed, prepare for use as follows:
adjust the water softening system;
add the regenerating salt;
add the rinse-aid and detergent.
5.1 Using the water softening system
The amount of scale contained in the water (water hardness index) can cause whit-
ish staining on the dry dishes, which tend to become dull over time. The dishwasher
is equipped with an automatic softening system which uses a special regenerat-
ing salt to reduce the hardness of the water. The dishwasher is factory set for water
hardness level 3 (average hardness 41-60°dF – 24-31°dH / 23.6-35 gpg). When us-
ing water of medium hardness, the regenerating salt container should be relled
after approximately 20 washing cycles. The salt container can hold approximately
1.7 Kg (3.75 lb) of salt in grains. Some models are equipped with an optical no-salt
indicator. In these models, the cap of the salt container contains a green oat which
descends as the salt concentration in the water drops. When the green oat can no
longer be seen, the container must be topped up with regenerating salt. The con-
tainer is situated at the bottom of the dishwasher. After removing the lower rack,
unscrew the salt container cap (ref. A g. 5-01) by turning it anticlockwise and pour
in the salt using the funnel (ref. A g. 5-02) supplied with the dishwasher. Before re-
placing the cap (ref. A g. 5-01), remove any salt residues from around the opening.
A
Fig. 5-01
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Commentaires sur ces manuels

Pas de commentaire