Smeg ST8246U Manuel télécharger pdf (Page 23)

USER INSTRUCTIONS

USER INSTRUCTION

5 OPERATING INSTRUCTIONS

BEFORE STARTING TO USE THE APPLIANCE, MAKE SURE YOU HAVE

READ AND UNDERSTOOD ALL THE WARNINGS CONTAINED IN CHAP-

TER 2 “IMPORTANT SAFETY INSTRUCTION”.

Once the dishwasher has been correctly installed, prepare for use as follows:

•

add the rinse-aid and detergent.

5.2 Using the rinse-aid and detergent dispensers

The detergent and rinse aid dispensers are situated on the inner part of the door:

the detergent dispenser (ref. A fig. 5-03) is on the left, and the rinse-aid

dispenser (ref. B fig. 5-03) is on the right.

WITH THE EXCEPTION OF THE SOAK PROGRAM, BEFORE EVERY

WASHING CYCLE IT IS NECESSARY TO ADD THE REQUIRED AMOUNT

OF DETERGENT TO THE DETERGENT DISPENSER. THE RINSE AID,

ON THE OTHER HAND, SHOULD ONLY BE ADDED AS REQUIRED.

Fig. 5-03

• adjust the water softening system;

• add the regenerating salt;

USER INSTRUCTIONS

5.2.1 Adding the rinse-aid

The rinse aid helps the dishes dry faster and prevents the formation of scale deposits

and staining; it is automatically added to the water during the final rinse cycle, from

the container situated on the inner side of the door.

To add rinse aid:

• Open the door.

• Rotate the container cover (ref. A fig. 5-04) anticlockwise by ¼ of a turn and re-

move it.

• Add the rinse aid until the container is full (approximately 140 ml). The optical

level indicator (ref. B fig. 5-04), on the side of the cap should be completely ob-

scured. Refill the rinse aid when the optical level indicator becomes clear again,

or when the rinse aid warning light illuminates (see “Description of controls”

manual).

• Replace the cover (ref. A fig. 5-04) by turning it in a clockwise direction until it is

fully closed.

• Use a cloth to remove any spillage of rinse aid which might lead to the formation

of excess foam.

5.2.2 Adjusting the rinse-aid dispenser setting

The rinse-aid dispenser can be set to one of 6 dierent levels. The dishwasher is

factory set for medium water hardness (selector set to “3”). To change the setting,

turn the dispenser selector (ref. c fig. 5-04) to the desired position: the amount of

rinse-aid dispensed is proportional to the position of this selector. Make sure that

the minimum amount of rinse-aid (selector turned to “1”) is approximately 1 ml and

the maximum amount (selector turned to “6”) is approximately 6 ml.

Fig. 5-04

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 49 50

Commentaires sur ces manuels

Pas de commentaire

Smeg ST8246U Manuel Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Smeg ST8246U