Smeg ST8246U Manuel Page 37

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 50
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 36
USER INSTRUCTIONS
35
EN
EN
30
USER INSTRUCTION
6.2 Cleaning the water intake lter
Clean the water inlet fil er at regular intervals. After closing the delivery tap, unscrew
the ring nut (ref. A fig. 6-01) on the water inlet pipe (using a pair of pliers, if neces-
sary) and delicately clean the fil er, removing deposits or impurities.
Then fi mly fix the pipe by tightening the ring nut (ref. A fig. 6-01) (use a pair of pliers,
if necessary).
6.3 Cleaning the spray arms
The spray arms can be easily removed for periodic cleaning of the nozzles, to pre-
vent possible clogging. Wash them under running water (at room temperature) and
carefully replace them in their seats, checking that their rotary movement is in no
way impeded; if this is not the case, make sure they have been mounted properly.
Removing the spray arms
To remove the upper spray arm (ref. A fig. 6-02), unscrew the locking ring (ref. B
fig. 6-02) by turning it clockwise. After cleaning, remount the spray arm in its seat
and tighten the locking ring by turning it anti-clockwise.
To remove the orbital spray arm assembly (ref. A fig. 6-03), take hold of the lower
arm (ref. B fig. 6-03) and pull the orbital unit upward (see fig. 6-03).
After cleaning, remount the orbital spray arm in its seat and push it down slightly un-
til it clicks into place on the lower spray arm (see fig. 6-03). Then remount the lower
spray arm into its seat and push it down slightly until it click into place (see fig. 6-03).
Fig. 6-01
EN
31
A
USER INSTRUCTION
Fig. 6-02
Fig. 6-03
A
B
.
Fig. 5-02
Fig. 5-03
Vue de la page 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 49 50

Commentaires sur ces manuels

Pas de commentaire