Smeg A1AU6 Manuel d'utilisateur

Table of Contents1. IMPORTANT SAFETY INSTRUCTIONS ... 42. DIMENSIONAL RE

Instructions for the Installer124.3 Mounting the rear top upstand1 Position the upstand above the top, so that holes A and B are aligned.2 Secure the

Instructions for the Installer135. ELECTRICAL CONNECTION WARNING ELECTRICAL SHOCK HAZARD- Disconnect power to the junction box before making connect

Instructions for the Installer14NOTE: Use this method only if local codes allow connecting the cabinet ground conductor to the neutralwire of the powe

Instructions for the Installer155.2 US installation and canadian installation / 4-wire branch circuitRefer to picture 2, - Disconnect the green or ye

Instructions for the Installer166. GAS SUPPLY REQUIREMENTS WARNINGEXPLOSION HAZARD- Use a new AGA or CSA-approved gas supply line.- Install a shut-

Instructions for the Installer173)The supply line must be fitted with an approved shut-off valve.This valve should be located in the same room as the

Important Safety Instruction41. IMPORTANT SAFETY INSTRUCTIONSREAD AND SAVE THESE INSTRUCTIONS – Your safety and the safety of others are very importan

Important Safety Instruction5NOTE: This range is manufactured for use with Natural gas. To convert to LP/Propane gas, seeinstructions in the Gas Conve

Instructions for the Installer6CAUTION: This unit is designed as a cooking appliance. Based on safety considerations, never use itfor warming or heati

Instructions for the Installer72. DIMENSIONAL REQUIREMENTS1 24” (61 cm) min. when bottom of wood or metal cabinet is protected by not less than ¼ “ (0

Instructions for the Installer82.1 Product dimensionsOverall dimensions: location of electrical connection points.A115 mm - 4 1/2”B 762 mm - 30 “C133

Instructions for the Installer93. UNPACKING, MOVING AND POSITIONING THE RANGECAUTION: This unit is designed as a cooking appliance. Based on safety co

Instructions for the Installer104. WALL FIXING AND ANTI-TIP DEVICE WARNING - All ranges can tip- Injury to persons could result- Install anti-tip

Instructions for the Installer113 Attach the two anti-tip brackets to the wallusing an appropriate fastener (for example,screws appropriate for the ty