Smeg KCVR9NE Manuel d'utilisateur télécharger pdf (Page 5)

KCVR9NE

Electronic control system instructions for use:

Technical Features:

• Power supply from mains: 230 VAC – 50/60 Hz

• Power consumption in standby: 20 mA

• Max. load applicable to LIGHTS connection: 150 W

• Max. load applicable to MOTOR connection: 400 W

(capacitor motors only)

• Microprocessor-controlled electronic control system.

• Loads managed by solid-state components, opto-isolated from the

mains.

• Hardware and software EMC filtering.

• Connection to electronic control board by flat cable (10 poles)

protected by flexible sheath (outside diameter 8 mm). Low voltage

circuits (5 V).

• Possibility of operating an optional load at mains voltage.

• Non-volatile internal memory (EEPROM) for storing system settings

and flags.

• Optional analog/digital input for sensor and/or external control.

• Phase-cutting motor control.

• SOFT-START light switch: turn the lights on gradually to guarantee

better performance of electronic components.

• Automatic sensing of mains frequency:

number 50 flashing on display = 230 VAC – 50 Hz mains,

number 60 flashing on display = 230 VAC – 60 Hz mains,

• Software-enabled reception of remote control commands: all the

hood's main functions can be controlled by an IR remote control

protected by a propriety code, operating at 24+1 bit and with an IR

carrier frequency of 36 KHz.

• Software set-up procedure for selecting and permanently storing

blower motor settings and enabling A.C. filter saturation alarm (for

filter hoods).

• FILTER saturation alarm and alarm reset control (hour TIMER

for hood work).

1 2 3 4 5 6 7 8

Pas de commentaire

Smeg KCVR9NE Manuel d'utilisateur Page 5