Smeg L30FABEBL Guide de dépannage télécharger pdf (Page 5)

The facia panel is supported by four M6 screws which

protrude from the front of the outer casing as shown

in figure 3. Ensure each screw is unscrewed

approximately one turn from the fully screwed in

position in order to create a 2mm gap as shown in

figure 4. Simply hang the facia panel onto the outer

casing ensuring that the corresponding keyhole

shaped holes engage the screwheads fully.

The control panel is located underneath the decorative frame on the bottom right hand side of the appliance.

CONTROL PANEL

POWER ON/OFF

FLAME BRIGHTNESS (5 settings)

Press to adjust the brightness level

FULL (5) - HIGH (4) - MEDIUM (3) - LOW (2) - DIM (1) - (LOOP)

HEATING (7 settings)

Press ∧ / ∨ to adjust the temperature level

60℃/99°F - 30℃/86°F - 28℃/82°F - 26℃/78°F - 24℃/75°F - 22℃/71°F - OFF -

(LOOP) Press button for 10s to convert between ℃ and ℉ (model dependent)

EMBER/FUELBED EFFECT

Press to select the dynamic fuelbed effect

9.0 FITTING THE DECORATIVE FRAME

2mm

Figure 3

Figure 4

GB IE

10.0 OPERATING THE APPLIANCE

1 2 3 4 5 6 7

Pas de commentaire

Smeg L30FABEBL Guide de dépannage Page 5