Smeg UKC3170P1 Manuel d'utilisateur télécharger pdf (Page 11)

Problem Possible cause Solution

The water drainage plug is

not correctly positioned.

Position the water drainage

plug in the correct way.

Food products are not

wrapped properly.

Wrap the food products better.

Temperature is set incor‐

rectly.

Refer to "Operation" .

Water flows on the rear

plate of the refrigerator.

During the automatic de‐

frosting process, frost

melts on the rear plate.

This is correct.

Water flows inside the refrig‐

erator.

The water outlet is clog‐

ged.

Clean the water outlet.

Food products prevent

that water flows into the

water collector.

Make sure that food products

do not touch the rear plate.

Water flows on the floor. The melting water outlet is

not connected to the evap‐

orative tray above the

compressor.

Attach the melting water outlet

to the evaporative tray.

The temperature in the ap‐

pliance is too low/too high.

The temperature regulator

is not set correctly.

Set a higher/lower tempera‐

ture.

The door is not closed cor‐

rectly.

Refer to "Closing the door".

The food products' tem‐

perature is too high.

Let the food products temper‐

ature decrease to room tem‐

perature before storage.

Many food products are

stored at the same time.

Store less food products at the

same time.

The thickness of the frost

is greater than 4-5 mm.

Defrost the appliance.

The door has been

opened often.

Open the door only if necessa‐

ry.

There is no cold air circu‐

lation in the appliance.

Make sure that there is cold

air circulation in the appliance.

If the advice does not lead to

the desired result, contact the

nearest Authorised Service

Centre.

Replacing the lamp

The appliance is equipped with

a long-life LED interior light.

11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Commentaires sur ces manuels

Pas de commentaire