Smeg S7212LS2P1 Manuel d'utilisateur télécharger pdf (Page 21)

Problem Possible cause Solution

There is no voltage in the

mains socket.

Connect a different electrical

appliance to the mains socket.

Contact a qualified electrician.

The appliance is noisy. The appliance is not sup‐

ported properly.

Check if the appliance stands

stable.

The lamp does not work. The lamp is in stand-by. Close and open the door.

The lamp is defective. Refer to "Replacing the lamp".

The compressor operates

continually.

Temperature is set incor‐

rectly.

Refer to "Operation".

Many food products were

put in at the same time.

Wait some hours and then

check the temperature again.

The room temperature is

too high.

Refer to climate class chart on

the rating plate.

Food products placed in

the appliance were too

warm.

Allow food products to cool to

room temperature before stor‐

ing.

The door is not closed cor‐

rectly.

Refer to "Closing the door".

There is too much frost and

ice.

The door is not closed cor‐

rectly or the gasket is de‐

formed/dirty.

Refer to "Closing the door".

The water drainage plug is

not correctly positioned.

Position the water drainage

plug in the correct way.

Food products are not

wrapped properly.

Wrap the food products better.

Temperature is set incor‐

rectly.

Refer to "Operation" .

Water flows on the rear

plate of the refrigerator.

During the automatic de‐

frosting process, frost

melts on the rear plate.

This is correct.

Water flows inside the refrig‐

erator.

The water outlet is clog‐

ged.

Clean the water outlet.

Food products prevent

that water flows into the

water collector.

Make sure that food products

do not touch the rear plate.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Smeg S7212LS2P1 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs Smeg S7212LS2P1