Smeg S7L148DF2P1 Manuel d'utilisateur Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 68
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
Problem Possible cause Solution
The temperature in the ap‐
pliance is too high.
Refer to "Door open alarm"or
"High temperature alarm".
The door is left open. Close the door.
The temperature in the ap‐
pliance is too high.
Contact a qualified electrician
or contact the nearest Author‐
ised Service Centre.
A symbol or symbol
is shown instead of numbers
on the Temperature Display.
Temperature sensor prob‐
lem.
Contact the nearest Author‐
ised Service Centre (the cool‐
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
A symbol is shown in‐
stead of numbers on the
Temperature Display.
Temperature sensor prob‐
lem.
Contact the nearest Author‐
ised Service Centre (the cool‐
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp does not work. The lamp is defective. Contact the nearest Author‐
ised Service Centre.
The compressor operates
continually.
Temperature is set incor‐
rectly.
Refer to "Operation".
Many food products were
put in at the same time.
Wait some hours and then
check the temperature again.
The room temperature is
too high.
Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm.
Allow food products to cool to
room temperature before stor‐
ing.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The Shopping is switched
on.
Refer to "Shopping function".
The compressor does not
start immediately after
pressing the Shopping, or
after changing the tempera‐
ture.
This is normal, no error
has occurred.
The compressor starts after a
period of time.
29
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 67 68

Commentaires sur ces manuels

Pas de commentaire