Smeg Electric Grill S340G Manuel d'utilisateur télécharger pdf (Page 5)

Instructions for the Installer

4. INSTALLING THE APPLIANCE

Installation must be carried out by a qualified engineer in compliance with the relevant regulations.

4.1 Electrical connection

The nameplate with the technical data, serial number and mark is clearly visible on the rear of the oven

and on the back of this user manual.

The nameplate must never be removed.

The appliance must be connected to earth in compliance with electrical system safety regulations.

If a permanent connection is used, the appliance's power supply line must be fitted with an omnipolar

breaking device with contact gap of at least 3 mm, located in an easily accessible position close to the

appliance itself.

If a socket and plug connection is used, check that they are of the same type. Do not use reducers,

adapters or junctions since they may cause overheating or burns.

Operation at 220-240 V

: use a type H05RR-F/H05V2V2-F three-

wire cable (cable of 3 x 1 mm

The earth wire (yellow-green) must be at least 20 mm longer than

the other wires at the end for connection to the appliance.

The manufacturer declines all responsibility for injury or damage caused by failure to comply with the

above regulations or deriving from tampering with even just one part of the appliance.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Pas de commentaire

Smeg Electric Grill S340G Manuel d'utilisateur Page 5