Smeg Built-in Electric Hob HBE64CAS Manuel d'utilisateur Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 6
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
5
CLEANING
IMPORTANT:
Always disconnect the appliance from the
electricity main before carrying out any
cleaning operation.
3) HOTPLATE
If you want to preserve the surface clean and bright,
periodically wash the hot plate with lukewarm soapy
water.
Following this, all parts should be thoroughly rinsed
and dried. Never wash them while they are still
warm and never use abrasive powders.
Do not allow vinegar, coffee, milk, salted water,
lemon or tomato juice from remaining in contact
with the enamelled surfaces for long periods of time.
WARNINGS:
- Correctly preserve the plate after use by
treating it with special products, easily
available on the market. This will keep the
surface of the plate clean and bright. The
operation will also prevent the formation of
rust.
- Any liquid overflowed the pans, must be
always remove with a rag.
8
CONVERSIONS
Disconnect the appliance from the mains
supply prior to any conversions being carried
out.
7) CHANGING THE TYPE OF POWER
SUPPLY
Although they leave our factory preset for single-
phase connection, certain appliances may by
converted to the threephase system.
Comply with the following instructions:
a) Remove the hotplate from the top of the cabinet,
overturn it, unscrew screw "Z" and remove under
part (see fig. 9).
b) Shift connecting plate on terminal according to
the following chart. This chart is also affixed to the
hob.
c) Insert a supply cable of adequate section (see
chart par. 10) through core hitch on the terminal
board.
d) Connect the phase and earth wires to the relative
terminal board.
e) Fix the supply cable in place using clamp.
f) Refit the hotplate, complying with the above
instructions in reverse.
FIG. 9 FIG. 10
Vue de la page 4
1 2 3 4 5 6

Commentaires sur ces manuels

Pas de commentaire