Smeg Cooking Hob P106 Manuel d'utilisateur télécharger pdf (Page 3)

Instructions for the installer

2. Positioning of hob

The following operation requires building and/or carpentry work so must be carried out

by a competent tradesman.

Installation can be carried out on various materials such as masonry, metal, solid

wood or plastic laminated wood as long as they are heat resistant (T 90°C).

2.1 Attachment to support structure

Create an opening with the dimensions shown in the figure in the top surface of the

counter, keeping a minimum distance of 50 mm from the rear border. This unit may be

set against walls that are higher than the hob as long as distance “X” (see figure) is

maintained to prevent damage to the walls due to overheating. Make sure there is a

minimum of 750 mm between the hot plate flames and any shelf that may be installed

directly above them. In case of installation on a hollow compartment with doors, a

separating panel has to be placed under the hob. Keep a minimum distance of 10 mm

between the bottom of the unit and the panel surface. The panel has to be easily

removable to allow access in the event of technical service.

1 2 3 4 5 6 7 8 ... 13 14

Pas de commentaire

Smeg Cooking Hob P106 Manuel d'utilisateur Page 3