Smeg Freestanding Cooker CSA150X-6 Manuel d'utilisateur télécharger pdf (Page 4)

Instructions for the Installer

2. INSTALLING THE APPLIANCE

It is the law that all gas appliances are installed by authorised persons.

Clearance around the cooker must comply with the requirements of

AS5601.

2.1 Positioning and levelling the appliance

The appliance is equipped with wheels and adjustable feet to simplify the

positioning procedure. To use the front wheels, screw in the foot as

shown here, so that the appliance rests on the front wheels. However, to

allow the appliance to be moved freely it must be lifted at the back. To do

this, proceed as follows:

use a 10 socket wrench to screw in

the 2 hex nuts underneath the oven

compartment: this raises the

appliance either to level it or to

allow it to be moved around.

Once all procedures are complete,

retighten the front feet and the hex

nuts to set the cooker stable and

level.

2.2 Electrical connection

Check that the voltage and size of the power supply line are as specified

on the nameplate inside the storage compartment.

This nameplate must never be removed.

The plug on the end of the power supply cable and the wall socket must

be of the same type (in compliance with the relevant national standards).

Check that the power supply line is properly earthed. The use of

reductions, adapters or junctions is not recommended.

The appliance's power supply line must be fitted with an omnipolar

breaking device with contact gap of at least 3 mm, located in an easily

accessible position close to the appliance itself.

1 2 3 4 5 6 7 8 9 ... 39 40

Pas de commentaire

Smeg Freestanding Cooker CSA150X-6 Manuel d'utilisateur Page 4