Smeg Glass Ceramic Induction Hob SE2642ID2 Manuel d'utilisateur télécharger pdf (Page 11)

Operation

Power boost setting

(cooking zones marked with a P)

The power boost setting makes additional power available for induction

cooking zones. A large quantity of water can be brought to the boil very

quickly.

The power boost setting operates for 10 minutes, after which the power level

is automatically reduced to cooking level 9.

1. A cooking zone must be switched on. The stand-by dot of the cooking

zone must light up. It may be necessary to press the

cooking zone

selection button

2. Press the

power button

once in order to activate the power boost set-

ting. The power display will show a P.

3. After 10 minutes the power boost setting will switch off automatically. The

P will go off and the power level will switch down to 9.

Note!

In order to terminate the power boost setting press the

minus button

the

power button

Dual circuit activation for radiant heating

elements (not for induction)

In order to switch on the outer heating circuit select the cooking zone (stand-

by dot lights up) and press the

power button

In order to switch the function off press the button again or switch the cooking

zone off.

Power management

For technical reasons two cooking zones always comprise a module and

have a maximum power level.

If this power range is exceeded when a higher power setting level or the

power boost function is switched on the power management system will

reduce the power setting of the corresponding cooking zone of the module.

The display of this cooking zone will initially blink; the maximum possible

power setting will subsequently be shown constantly.

Modules (power management)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Smeg Glass Ceramic Induction Hob SE2642ID2 Manuel d'utilisateur Page 11