Smeg Glass Ceramic Induction Hob SE2642ID2 Manuel d'utilisateur télécharger pdf (Page 15)

Instructions for assembly

GB

31

Clips

• Drive the clips into the worktop cut-out at

the intervals indicated. It is not necessary

to adjust the height due to the horizontal

stop motion device.

• Important! The horizontal drive of the clips

must be flush with the worktop (avoid the

risk of breaks).

• Position the hob according to the

illustration on the left side (a), align it (b)

and insert the clips (c).

• Screws may be used to fasten the clips.

Important!

There is a risk of breakage if the hob is

canted or subjected to stress during

installation!

Minimum distance to adjacent walls

Cut-out dimension

Outer dimensions of the hob

Cable routing in rear wall

Installation height

Bracket

• Insert the hob and align it.

• From the bottom, insert the brackets with

screws in the holes provided for fastening

the brackets, align the brackets and screw

them tight.

• Tighten the screws with a hand screw

driver only; do not use a battery-operated

screw driver.

• In the case of thin worktops make sure

that the brackets are correctly positioned.

Important!

There is a risk of breakage if the hob is

canted or subjected to stress during

installation!

Minimum distance to adjacent walls

Cut-out dimension

Outer dimensions of the hob

Cable routing in rear wall

Installation height

Type

Type

1 2 ... 10 11 12 13 14 15 16 17

Commentaires sur ces manuels

Pas de commentaire