Smeg ALFA141XE Manuel d'utilisateur télécharger pdf (Page 5)

Instructions for the installer

When linking up to mains by plug and socket, the connection must be

completed with a three-core plug of adequate capacity (25A), or, for

operation at 380-415V2N∼ or 380-415V3N∼, a five-core plug (16A). The

plug and wall-mounted socket must be of the same type (in accordance

with CEI regulations). Make sure that the supply line is suitably earthed.

Avoid use of adapters and shunts.

If the appliance is connected to the electrical mains supply in a

permanent manner, install a multipolar cut-out device on the line, with

contact opening distance equal to or greater than 3 mm located near the

appliance and in an easily reachable position.

WARNING: if the phase voltage drops below 190 VAC, the performance

of the oven may suffer, not due to the product itself.

The terminal marked with this symbol connects parts together that are

normally at zero potential. Connect the appliances appropriately using

this terminal in order to make sure that they are equipotential.

2.1.1 Safety thermostat

The oven is equipped with a safety device that takes action in case of

serious malfunction. To re-arm the safety device you must contact the

technical assistance service.

The manufacturer declines all responsibility for damage to persons

or things caused by the non-observance of the above prescriptions or

deriving from tampering with any part of the appliance.

2.2 Levelling

Level the oven on the ground using the four adjustable feet. In order to

adjust them, loosen the lock nut and unscrew the foot. The adjustment

screws have a range of 10 mm.

1 2 3 4 5 6 7 8 9 10 ... 16 17

Pas de commentaire

Smeg ALFA141XE Manuel d'utilisateur Page 5