Smeg FP850APZ Manuel d'utilisateur télécharger pdf (Page 21)

Instructions for the User

12.3 Removing the inside glass with the door cold

The glass in the door should always be kept thoroughly clean. For easier cleaning, the door glazing can

be fully removed by proceeding as described below. After opening the door and locking it in place as

described in point “12.2 Removing the door”, remove the three panes of glass. All extracted in two

stages: first extract it from the guide “A” (see detail) by sliding it towards you and lifting it slightly, then

also free it from the guide “B”. If the door should close during these operations, simply relock one of the

hinges as described in point “12.2 Removing the door”. The panes of glass can now be washed

separately.

Use absorbent kitchen roll; remove stubborn dirt with a damp sponge and ordinary detergent.

Warning: before removing the panes of glass, make sure that at least one of the door's hinges has been

locked in open position as described in points “12.2 Removing the door”. This operation might have to be

repeated during the glass removal process if the door is accidentally freed.

Replace the panes of glass in the same order and in the same position as before removal, taking care to

push the last pane marked “PYROLISE” into the guide A to lock it in place. To be sure that the panes of

glass are fitted the correct way round, check that the wording on them is legible with the door open.

When complete, release the hinges and close the door.

In the diagram below, the 3 panes of glass have been removed.

1 2 ... 16 17 18 19 20 21 22 23

Pas de commentaire

Smeg FP850APZ Manuel d'utilisateur Page 21