Smeg SE900-5 Manuel d'instructions télécharger pdf (Page 4)

Instructions for the installer

2 INSTALLATION

2.1 Electrical connection

Check that mains voltage and power cable ratings are as per the

indications provided on the label attached to the oven door frame.

This label must never be removed.

It is obligatory for the electrical system to be grounded according to the

methods required by safety rules.

If a plug and socket connection is being used make sure that the plug

and socket are compatible. Avoid use of adapters and shunts as these

could cause overheating and risk of burns.

If a fixed connection is being used fit power line with an omnipolar circuit

breaker with a contact opening gap equal to or greater than 3 mm in an

easily accessible position in proximity to the oven.

Remove rear cover by loosening relevant screws to gain access to the

terminal strip. Secure power cable to oven by means of the appropriate

fitting.

If the power cable is replaced, the wire

section on the new cable must not be

less than 1.5 mm

(3 x 1.5 cable),

keeping in mind that the end to be

connected to the hob must have the

ground wire (yellow-

reen) longer by

at least 20 mm.

The manufacturer declines all responsibility for damage to person

or things caused by non-observance of the above prescriptions or b

interference with any part of the appliance.

1 2 3 4 5 6 7 8 9 ... 17 18

Pas de commentaire

Smeg SE900-5 Manuel d'instructions Page 4