Smeg KSET96 Manuel d'utilisateur télécharger pdf (Page 12)

12GB

220

264

Hood Type 60 90

L 598 898

INSTALLATION

Drilling the Support surface and Fitting the Hood

SCREW FITTING

• The hood support surface must be 220 mm

above the bottom surface of the wall units.

• Drill the support with a ø 4,5 mm drill bit, using

the drilling template provided.

• Cut a hole ø 150 mm in size on the support

surface, using the drilling template provided.

• Fix using the 4 screws 12a (4,2 x 44,4) provided.

SNAP-ON FITTING

• The hood can be installed either directly on the

bottom surface of the wall units (min. 650 mm

above the hob) using snap-on side supports.

• Cut a fitted opening in the bottom surface of

the wall unit, as shown.

• Insert the hood until the side supports snap into

place.

• Lock in position by tightening the screws Vf

from underneath the hood.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Pas de commentaire

Smeg KSET96 Manuel d'utilisateur Page 12