Smeg ALFA161XK Manuel d'utilisateur télécharger pdf (Page 4)

Instructions for the installer

2. INSTALLATION OF THE OVEN

The oven must be set up on a perfectly flat surface and left standing

free. Make sure to allow enough room at the back for easy access to the

terminal strip for connection of the power cable to mains.

Installation must be carried out by a qualified technician in compliance

with applicable regulations in force.

Keep the appliance at least 5 cm from any walls at the sides and back.

2.1 Electrical connection

Make sure that the power line voltage matches the specifications

indicated on the rating plate located to the rear of the oven. This rating

plate must never be removed.

The oven is supplied complete

with a H07RN-F three-core

supply cable for operation from a

220-240V∼ power supply.

For operation from a 380-

415V2N∼ or 380-415V3N∼ power

supply, the original cable must

be replaced and the terminal

board connections modified

accordingly. For access to the

terminal board, remove the door

located at the back of the oven.

The standard cable is of the three-core 3 x

4 mm

H07RN-F type.

For operation from a 380-415V2N

∼

o 380-

415V3N

∼

power supply, replace the standard

cable with one of the H07RN-F type. The

cross section of the leads of the latter cable

must not be less than 2.5-1.5 mm

(4 x 2.5

- 5 x 1.5 mm

); the ground (yellow-

reen)

of the termination to be linked up to the oven

must be at least 20 mm longer.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Smeg ALFA161XK Manuel d'utilisateur Page 4