Smeg S45MX2 Manuel de service télécharger pdf (Page 30)

GB-IE

Instructions for the Installer

12 INSTALLING THE APPLIANCE

12.1 Electrical connection

The nameplate with the technical data, serial number and mark is in a

visible position on the oven door frame.

The nameplate must never be removed.

The appliance must be connected to earth in compliance with electrical

system safety regulations.

If a permanent connection is used, the appliance's power supply line must

be fitted with an omnipolar breaking device with contact gap of at least 3

mm, located in an easily accessible position close to the appliance itself.

If a socket and plug connection is used, check that they are of the same

type. Do not use reducers, adapters or junctions since they may cause

overheating or burns.

12.2 Positioning the oven

The appliance is designed for building-in to cabinets made from any heat-

resistant material. Comply with the dimensions shown in following pictures.

When installing in tall units bear in mind that the top/rear of the unit must

have an opening 100 mm deep.

Screw the 4 screws into the inside of the frame.

1 2 ... 25 26 27 28 29 30

Pas de commentaire

Smeg S45MX2 Manuel de service Page 30