Smeg SC336WH Manuel de service télécharger pdf (Page 22)

Instructions for the User

10.6.2 Removing doors with pins

Open the door completely and insert the pins (supplied) into the holes

from the inside. Close the door to an angle of about 45° and lift it off. To

reassemble, fit the hinges into their grooves, then lower the door into place

and extract the pins.

10.7 Removing the door glazing

The glass in the door should always be kept thoroughly clean. For easier

cleaning, the door glazing can be fully removed by proceeding as

described below. After blocking the door in position as described in point

"10.6 Removing the door", remove the inner glass using leverage as

shown in figure 1, and release the 4 pins which fix the glass to the door. If

your oven also has the middle glass (figure 2) this can simply be lifted out.

After cleaning, first fit the middle glass (if featured on your oven) and then

replace the inner glass, using the oven door supports as a fulcrum as

shown in figure 3 (see detail A in figure 3. Once the glass has been fitted

on the door, apply a little pressure against the 4 fixing pins.

If the door should close during these operations, simply relock one of the

hinges as described in point "10.6 Removing the door". The panes of

glass can now be washed separately.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Smeg SC336WH Manuel de service Page 22