Table of Contents3EN1 Installation 81.1 Dimension Requirements 81.2 Product dimensions 91.3 Unpacking, moving and positioning the range 101.4 Wal
Installation123. From the floor, measure the height of the notch found on the bracket. This notch corresponds to the centerline of the holes for the s
Installation13ENInstructions for floor mounting (secondary system)The secondary anti-tip device is to be attached to the floor when it is not possible
Installation141.5 Electrical requirementsMake sure that the power line rating matches the specifications indicated on the ID plate. The ID Plates are
Installation15EN• lf codes permit and a separate ground wire is used, it is recommended that the suitability of the ground path be checked by a quali
Installation16U.S. Installation only / 3-wire branch circuitRefer to figure, where local codes allow the connection of the ground wire from the oven t
Installation17EN• Connect to a 20A fuse or circuit breaker. Connect to copper wire, or, if connection is made to aluminum house wiring, use UL-listed
Installation18Always use pipe-joint compound made for use with NATURAL GAS and L.P. GAS between pressure regulator D and NPT adaptor C and between pre
Installation19EN• Natural Gas: manifold pressure 4” W.C.P. Incoming line pressure 3.5”-10.5” W.C.P.• LP Gas: manifold pressure 11” W.C.P. Incoming
Installation20Assembling the backguardThe backguard must always be positioned and secured correctly on the appliance.1. Loosen the 6 screws on the bac
Important Safety Instructions4WARNINGTIP OVER HAZARD• A child or adult can tip the range and be killed.• Make sure that the anti-tip device has been
Important Safety Instructions5ENThe safety messages will inform you of potential hazards, on how to avoid the risk of injury and what can occur if the
Important Safety Instructions6• Read all instructions• Proper installation is your responsibility. Have a qualified technician install and ground th
Important Safety Instructions7EN• Never modify or alter the construction of the appliance. For example, do not remove adjustable legs, panels, wiring
Installation81 Installation1.1 Dimension Requirements1. min. clearance from the sides of range to side wall or other combustible material;2. min. cabi
Installation9EN1.2 Product dimensionsOverall dimensions: location of gas and electrical connection points.Check the location where the range is to be
Installation101.3 Unpacking, moving and positioning the range• It is recommended that the grates, the griddle plate and burner heads, burner caps, fr
Installation11EN1.4 Wall attachment and anti-tip deviceInstructions for wall mounting (primary system)The anti-tip brackets are to be attached to the
Commentaires sur ces manuels