Smeg XXSC111P Manuel d'utilisateur télécharger pdf (Page 23)

Instructions for the User

• The oven should be operated at the maximum heat setting for 15/20

minutes after use of specific products, to burn off the residues left

inside the oven.

The pizza plate must be washed separately;

• Before cleaning, remove any dirt burnt onto the stone with the aid of a

metal spatula or a scraper of the kind used for cleaning ceramic hobs;

• For best results, the stone must still be warm; otherwise, wash it in hot

water;

• Use metal mesh or non-abrasive scotch-brite pads, dipped in lemon or

vinegar;

• Never use detergents;

• Never wash in the dishwasher;

• Never leave the stone to soak;

• The damp stone must not be used for a least 8 hours after the end of

the cleaning procedures;

• Over time, slight cracks may appear on the surface of the stone. This is

due to the normal expansion of the stone's finishing glazes at high

temperatures.

• To put the pizza plate base back in place, push it firmly down against

the oven's bottom panel and ensure it engages with the plate of the the

pizza heating element (detail A Fig. 2).

11.5 Cleaning the door glazing

The glass in the door should always be kept thoroughly clean. Use

absorbent kitchen roll; remove stubborn dirt with a damp sponge and

ordinary detergent.

Do not use abrasive or corrosive cleaners for cleaning the door glazing.

(e.g. powder products, oven-cleaner sprays, stain removers and metal

scouring pads).

Do not use rough or abrasive materials or sharp metal scrapers to clean

the oven's glass doors since they may scratch the surface and cause the

glass to shatter.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Pas de commentaire

Smeg XXSC111P Manuel d'utilisateur Page 23