Smeg XXSC111P Manuel d'utilisateur télécharger pdf (Page 26)

Instructions for the User

11.6.3 Setting the cleaning cycle

Use PT2 to select one of the two pyrolysis functions ( and ) with the

oven in ON status (see point 7.4, Function Selection).

To start the cleaning (Pyrolysis) cycle, first press knob PT1 twice to set its

duration ( ).

Turn knob PT1 to the right or left to increase or decrease the cycle

duration between a minimum of 1h 30m and a maximum of 3h 00m.

(Except for the function where the cycle duration is fixed at 1h 30m).

The message PYro will appear on DSPL 3 to indicate that cleaning is in

progress. The temperature symbol « » will come on and the degree sign

«°» will flash to indicate that the internal pyrolysis temperature has not yet

been reached. When the preset temperature is reached the degree

symbol «°» will remain constantly on.

About 2 minutes after the cleaning (Pyrolysis) cycle starts an interlock

device which prevents opening of the door will be tripped.

The symbol illuminates on dps3 to indicate that this interlock device has

been activated.

To select a cleaning cycle with delayed start, after setting the duration

press PT1 once. The symbol and the current time will appear on the

display.

Turning PT1 to the right increases the time, allowing the cleaning start

time required to be set.

A few seconds after the required duration is set, the and symbols

will stop flashing, and the oven will start to wait for the starting time set.

It is not possible to select any functions once the door interlock has been

activated. Wait for the symbol to go out.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Smeg XXSC111P Manuel d'utilisateur Page 26