Contents 1. INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 36 2. INSTALLATION OF THE APPLIANCE________________________ 38 3. ADAPTATION TO D
Instructions for the user 44 5. DESCRIPTION OF CONTROLS 5.1 Front control panel All the cooker controls and commands are on the front panel.
Instructions for the user FUNCTION SWITCH KNOB Turn the knob to select from the following functions: NO FUNCTION SET LOWER HEATING ELEMEN
Instructions for the user 46 5.2 Analog Programmer 5.2.1 Regolazione dell'ora To set the correct time, pull out the knob A and turn it cloc
Instructions for the user 5.3 Electronic Analogue Clock (on some models only) LIST OF FUNCTIONS MINUTE-MINDER BUTTON AUTOMATIC S
Instructions for the user 48 5.3.3 Minute-minder This function does not stop cooking but just triggers the beeps. - When the key is pressed the
Instructions for the user 5.3.4 Programming Cooking duration time: the 2nd button can be used to set the cooking time. Before setting it, turn
Instructions for the user 50 Cooking start: as well as setting a cooking duration time, the user can also set the cooking start time (up to 12 hour
Instructions for the user 6. USE OF THE COOKING HOB 6.1 Lighting of the cooking hob burners Before lighting the hob burners check that the
Instructions for the user 52 6.2 Practical advice for using the cooking hob burners For better use of the burners and lower gas consumption, use c
Instructions for the user 7. USE OF THE OVEN Before using the oven make sure that the the analog programmer shows the symbol (see paragraph
Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY
Instructions for the user 54 8. AVAILABLE ACCESSORIES The oven features 4 support positions for plates and racks of different height. Oven gri
Instructions for the user 9. COOKING HINTS 9.1 Traditional cooking FUNCTION SWITCH THERMOSTAT SELECTOR SWITCH FROM 50° TO 250
Instructions for the user 56 Multiple cooking is possible as long as the cooking temperature of the different foods is the same. Keep the o
Instructions for the user 9.4 Hot-air grilling FUNCTION SWITCH THERMOSTAT SWITCH FROM 50° TO 250°C Ensures uniform heat d
Instructions for the user 58 9.6 Spit cooking FUNCTION SWITCH THERMOSTAT SWITCH FROM 50° TO 200°C Prepare the spit with t
Instructions for the user 9.7 Recommended cooking table Cooking times, especially meat, vary according to the thickness and quality of the food an
Instructions for the user 60 HOT-AIR COOKING LEVEL FROM BELOW TEMPERATURE (°C) TIME IN MINUTES FIRST COURSES LASAGNE O
Instructions for the user 10. CLEANING AND MAINTENANCE 10.1 Cleaning stainless steel Before performing any operations requiring access to
Instructions for the user 62 10.2.2 Burner caps, flame cap crowns and burners To facilitate cleaning, caps, flame cap crowns, and burners are all
Instructions for the user For easier cleaning, the storage drawer underneath the oven can becompletely removed. Pull it right out and raise the f
Introduction DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. DO NOT INSTALL THIS APPLIAN
Instructions for the user 64 10.4 Door glass The door glass should always be kept clean. Use absorbent kitchen paper to clean. In case of tough s
Instructions for the user 11.3 Oven door seal To permit thorough cleaning of the oven, the seal may be removed. Before removing the seal, take
Instructions for the installer 38 2. INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by competent persons. Corg
Instructions for the installer The manufacturer declines all responsibility for damage to persons or things caused by non-observance of the above
Instructions for the installer 40 3. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the app
Instructions for the installer 3.2 Burner and nozzle characteristics table Burner Rated heating capacity(kW) LPG – G30/G31 28/37 mbar Nozzl
Instructions for the installer 42 4. FINAL OPERATIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the g
Instructions for the installer 4.3 Positioning and levelling of the appliance Having carried out the electricity and gas hook-up, level the appli
Commentaires sur ces manuels