Smeg Dual Fuel Cooker A3-5 Manuel d'utilisateur télécharger pdf (Page 4)

Instructions for the installer

2. INSTALLATION OF THE APPLIANCE

It is the law that all gas appliances are installed by competent persons.

Corgi gas installers are approved to work to safe and satisfactory

standards. All gas installation, servicing and repair work must be in

accordance with the gas safety regulations 1984 (installation and use) as

amended 1990.

It can be placed against walls higher than the hob, at a distance of at

least 50 mm from the side of the appliance, as shown in the drawings A

and B relating to the installation classes. Wall units or extractor hoods

located above the hob must be at least 750 mm away from it.

A B

SLOT IN FREE STANDING

2.1 Positioning and levelling of the appliance

The appliance is equipped with wheels and adjustable feet to simplify the

positioning procedure. To use the front wheels, screw in the foot as

shown here, so that the appliance rests on the front wheels. However, to

allow the appliance to be moved freely it must be lifted at the back. To do

this, proceed as follows:

use a 10 socket wrench to screw in

the 2 hex nuts underneath the oven

compartment: this raises the

appliance either to level it or to

allow it to be moved around.

Once all procedures are complete,

unscrew the front feet and the hex

nuts to set the cooker stable and

level.

2.2 Electrical connection

Make sure that the power line voltage matches the specifications

indicated on the rating plate located inside the storage compartment.

This rating plate must never be removed.

1 2 3 4 5 6 7 8 9 ... 35 36

Pas de commentaire

Smeg Dual Fuel Cooker A3-5 Manuel d'utilisateur Page 4