Smeg GKCO955 Manuel d'utilisateur

Contents 20 1. INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 21 2. POSITIONING OF HOB ___________________________________ 23 3. ELECTRICAL

Instructions for the installer 29 5.2 Regulation for LPG Loosen screw A and push support B all the way. Use a double head wrench to remove nozzle

Instructions for the installer 30 5.3 Regulation for G25/25 mbar The hob has been inspected for G25 (2L) at a pressure of 25 mbar. To allow the uni

Instructions for the installer 31 6. FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards, th

Instructions for the installer 32 6.3 Arrangement of burners on hob BURNERS 1 Auxiliary 2 Semi-rapid 3 Rapid 4 Double crown 6.4 Lubricatio

Instructions for the user 33 7. USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitte

Instructions for the user 34 7.2 Practical advice for using the burners For better burner performance and minimum gas consumption, flat bottomed, e

Instructions for the user 35 8. LEANING AND MAINTENANCE Before any intervention, disconnect the power supply of the device. 8.1 Cleaning

Instructions for the user 36 8.2.1 Ignition plugs and safety devices For good functioning of the lighting ignition plugs and the safety devices,

Introduction 21 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIR

Introduction 22 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE

Instructions for the installer 23 2. POSITIONING OF HOB The following operation requires building and/or carpentry work so must be carried o

Instructions for the installer 24 In case of installation on a hollow compartment with doors, a separating panel has to be placed under the

Instructions for the installer 25 3. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown

Instructions for the installer 26 4. GAS CONNECTION Connection to the gas mains may be made with a rigid copper pipe or with a flexible pipe and

Instructions for the installer 27 4.1 Connection to LPG Use a pressure regulator and make the connection to the tank according to the provisions

Instructions for the installer 28 5. ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appl