Contents 21 1 INSTRUCTIONS FOR SAFE AND PROPER USE ____________________ 22 2 POSITIONING OF THE HOB ____________________________________ 24 3 E
Instructions for the installer 30 5.2 Regulation for LPG Loosen screw A and push support B all the way. Use a double head wrench to remove
Instructions for the installer 31 5.3 Regulation for natural gas The hob has been inspected for G20 (2H) natural gas at a pressure of 20 mba
Instructions for the installer 32 5.5 Regulation of primary air Referred to distance “X” in mm. Burner G20 20 mbar G30/G31 G110 30/37 mbar
Instructions for the installer 33 6 FINAL OPERATIONS Having carried out the above adjustments, reassemble the appliance following, backwards
Instructions for the installer 34 6.3 Arrangement of burners on hob Burners 1. Auxiliary 2. Semirapid 3. Rapid 4.
Instructions for the user 35 7 USING THE HOB Before turning on the burners, make sure that the burner rings, caps and grids have been fitted
Instructions for the user 36 7.2 Practical advice for using the burners For better burner performance and minimum gas consumption, flat bott
Instructions for the user 37 8 CLEANING AND MAINTENANCE Never use a steam jet to clean the appliance. Before any intervention, disconnect th
Instructions for the user 38 8.2 Cleaning of cooking hob components CAUTION: do not wash these components in a dishwasher. In normal use of t
Introduction 22 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENT
Introduction 23 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CAS
Instructions for the installer 24 2 POSITIONING OF THE HOB The following operation requires building and/or carpentry work so must be carrie
Instructions for the installer 25 In case of installation on a hollow compartment with doors, a separating panel has to be placed under the hob.
Instructions for the installer 26 3 ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown
Instructions for the installer 27 4 GAS CONNECTION Connection to the gas mains may be made with a rigid copper pipe or with a flexible pipe
Instructions for the installer 28 4.1 Connection to LPG Use a pressure regulator and make the connection to the tank according to the provisi
Instructions for the installer 29 5 ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, disconnect the
Commentaires sur ces manuels