Smeg SNL34AX1 Manuel d'utilisateur télécharger pdf (Page 16)

Instructions for the user

7 USING THE HOB

Before turning on the burners, make sure that the burner rings, caps

and grids have been fitted correctly.

In the ultrarapid burner, notch A must be aligned with pin B.

Grid C provided is intended for use with woks (Chinese pans).

Adapter D comes only with open grids models and is intended for use

with small sized vessels.

7.1 Ignition of the burners

The device is fit with electronic ignition. Simply press and

simultaneously turn the knob counter-clockwise on the low point flame

symbol, until the burner is ignited. In models with safety valve, the knob

has to be turned to the ignition symbol before it is pressed, and after

ignition the knob has to be kept pressed for about 2 seconds to keep

the flame lit and to activate the safety device.

The burner might go off when the knob is released. In this case repeat

the aforesaid operation keeping the knob pressed for more than 2

seconds.

Should the burners go off accidentally in the models with valves, a

safety device will trip after approximately 20 seconds to block the gas

outlet even if the cock is open.

7.2 Practical advice for using the burners

For better burner performance and minimum gas

consumption, flat bottomed, even pans must be used,

with covers and proportional in size to the burners (see

paragraph “7.3 Diameter of the pans”).

To avoid overcooking or damage to the surface top

1 2 ... 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Smeg SNL34AX1 Manuel d'utilisateur Page 16