Smeg SSA91MFP1 Manuel d'utilisateur télécharger pdf (Page 14)

Instructions for the installer

6. USE OF THE HOB

6.1 Lighting of the hob burners

Before lighting the hob burners check that the flame caps are in the correct position and that

their burner caps are in place, making sure that the holes A in the flame caps correspond to the

spark plugs and thermocouples.

The optional grid B is for use with “woks” (Chinese pans).

To prevent deterioration of the hob we have equipped the cooker with a raised pan stand C to

be placed underneath pans more than 26 cm in diameter.

The supplied reduction rest C is used also for small pans.

The drawing next to each knob shows the corresponding burner. The

appliance has an electronic lighting device. Simply press and turn the knob

anticlockwise to the minimum flame symbol

, until the flame is lit. Hold the

knob down for a few seconds to allow the thermocouples to heat up. The

burner may go out when the knob is released: this is because the

thermocouple has not been sufficiently heated. Repeat the operation

holding down the knob a little longer. This operation is not necessary for

burners without thermocouples.

For models with thermocouples, should the burner accidentally go out, a safety device will be

activated which stops the gas flow even if the tap is open.

6.2 Practical advice for using the hob burners

For better use of the burners and lower gas consumption, use covered vessel that are

proportional in size to the burner to prevent the flame from licking the sides (see paragraph

“6.3 Diameter of the vessels to be used on each burner”). When water reaches the boiling

point, lower the flame so that it doesn’t overflow. To avoid burns or damage to the hob, all

vessels or griddle plates must be placed within the perimeter of the hob. All vessels must have

a flat and smooth bottom. When using fats or oils, be extremely careful that they don’t

overheat and catch fire.

If the flame accidentally goes out, turn off the control knob and wait at least 1 minute before

trying to re-light the burner.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Pas de commentaire

Smeg SSA91MFP1 Manuel d'utilisateur Page 14