Smeg XXPTS725 Manuel d'utilisateur

Table of Contents 19 1. Precautions for safety and use ________________________ 20 2. Fitting the appliance in the top ________________________ 21

Instructions for the Installer 28 5.4 Adjusting the primary air flow Refers to the gap “X” in mm. BURNER G20 20 mbar G30/G31 30/37 mbar Auxil

Instructions for the Installer 29 5.8 Hob burner layout Burner type 1 Auxiliary 2 Semi rapid 3 Rapid 4 Double flame 5 Ultra rapid 6 Rapid 7 Rapid

Instructions for the User 30 6. Description of controls 6.1 The front panel All the hob's control and monitoring devices are placed togeth

Instructions for the User 31 7. Using the hob Check that the fixing rings, burners, flame diffuser rings and pan stands are fitted correctly.

Instructions for the User 32 7.4 Pan diameters BURNERS 1 Auxiliary 2 Semi rapid 3 Rapid 4 Double flame 5 Ultra rapid 6 Rapid 7 Rapid 8 Doubl

Instructions for the User 33 8. Cleaning and maintenance Before carrying out any operations, disconnect the appliance from the electricity su

Precautions for Safety and Use 20 1. Precautions for safety and use THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. TAKE GOOD CARE OF IT AND K

Instructions for the Installer 21 2. Fitting the appliance in the top The procedures required below must be carried out by a skilled builder a

Instructions for the Installer 22 Fit the insulating gasket provided carefully around the outside edge of the hole made in the top as shown below

Instructions for the Installer 23 3. Electrical connection Check that the power supply line voltage and size are as specified on the nameplate un

Instructions for the Installer 24 4. Gas connection If the appliance is installed above an over, the gas hose must be passed around the back of

Instructions for the Installer 25 4.1 Bottled gas connection Use a pressure regulator and make the connection to the gas cylinder in accordance wi

Instructions for the Installer 26 5. Adapting to different types of gas Before carrying out the operations described below, disconnect the app

Instructions for the Installer 27 5.2 Adjusting for bottled gas Undo the screw A and push the support B fully down. Remove the nozzle C with a sp