Smeg FD 32 AP Manuel d'utilisateur télécharger pdf (Page 9)

en en

1 = Lowest cooling setting (Warmest setting)

5 = Highest cooling setting

(Coldest setting)

(Or)

Min. = Lowest cooling setting

(Warmest setting)

Max. = Highest cooling setting

(Coldest setting)

The average temperature inside the fridge

should be around +5°C.

Please choose the setting according to the

desired temperature.

Y

ou can stop operation of your device by

adjusting the thermostat knob to “0” position.

Please note that there will be different

temperatures in the cooling area.

The coldest region is immediately above the

vegetable compartment.

The interior temperature also depends on

ambient temperature, the frequency with which

the door is opened and the amount of foods

kept inside.

Frequently opening the door causes the interior

temperature to rise.

For this reason, it is recommended to close

the door again as soon as possible after use.

Setting the operating

temperature

(Fig. 2)

The operating temperature is regulated by the

temperature control.

Prior to startup

Before you begin operating your device, the

following points should be re-checked for

safety:

•

Is the device standing properly on the floor?

• Is there sufficient space for good air

circulation?

• Is the interior clean? (Also see the section

“Cleaning and care”)

• Set the thermostat knob half way between

1 and 5 or Min. and Max.

• Now connect the device to the mains.

The compressor is turned on; the interior light

comes on when the door is opened.

Do not place foodstuff into the refrigerator until

the temperature has reached the desired level.

4

Warm Cold

1 2 3 4 5

(Or) Min. Max.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire