Smeg FA550X Mode d'emploi Page 19

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 37
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 18
46
MAINTENANCE AND CLEANING
Before any cleaning or maintenance operation, unplug the
appliance from the mains or disconnect the electrical
power supply.
Periodically clean the refrigerator and freezer
compartments with a sponge dampened in a solution of
lukewarm water and vinegar. Rinse and dry. Never use
detergents or abrasives. Never clean refrigerator parts
with flammable fluids. The fumes can create a fire hazard
or explosion.
Clean the outside with a sponge dampened in lukewarm
water.
Dry with a soft cloth.
Do not use steam cleaners
Clean the condenser and seal.
NOTE
: The refrigeration system pipes are located near the
defrost pan and can become hot. Periodically clean them with
a vacuum cleaner.
Always disconnect the refrigerator from the power
supply before replacing any light bulbs.
Removal of the refrigerator light cover:
Loosen the screw that secures the light cover
Pull downwards and slide the cover towards the rear of
the refrigerator.
Replace the bulb with one of the same type available only
from our After-sales Service Centre.
Put the light cover back into place, repeat the above
steps in reverse order.
How to replace the freezer upper compartment bulb:
Remove the light shield by pressing the side sections;
Remove the bulb and replace it with one of the same type
available only from our After-sales Service Centres or
authorized dealers;
Put the light shield back into place, repeat the above
steps in reverse order.
How to replace the lower bulb in the refrigerator and
freezer compartments (on some models):
remove the light shield by grasping its upper central part;
pull the front and, at the same time, slightly turn the
shield to one side;
remove the bulb and replace it with one of the same type
available only from our After-sales Service Centres or
authorized dealers.
To replace the light shield:
grasp the upper central part of the light shield;
insert the tabs of one side of the shield into the grooves;
gently bend the light shield in the centre to insert the tabs
on the other side.
How to replace the dispenser bulb (on some models):
grasp the bulb in the dispenser recess;
remove the bulb and replace it with one of the same type
available only from our After-sales Service Centres or
authorized dealers.
61502000GB.fm Page 46 Friday, April 22, 2005 5:00 PM
Vue de la page 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 36 37

Commentaires sur ces manuels

Pas de commentaire