Smeg FA550X Mode d'emploi télécharger pdf (Page 32)

ELECTRICAL CONNECTION

Regulations require that the appliance is earthed. The

manufacturer declines all liability for injury to persons or animals

and for damage to property resulting from failure to observe the

prescriptions.

Make sure that the installation and the electrical connection are

carried out by a qualified technician according to the

manufacturer’s instructions and local safety regulations.

If your new appliance is provided with a plug with no earth wire,

connect the green/yellow earth wire (A) to the earth screw

located on the appliance (B) (see figure).

Ensure that the voltage indicated on the appliance data plate

corresponds to the mains voltage.

The plug of the appliance must be easily accessible even after

installation so that the appliance can be unplugged if necessary.

If this is not possible, connect the appliance to the mains supply

by means of a two-pole switch with minimum break distance

between contacts of 3 mm, fitted at an easily accessible point.

If the power supply cable plug and socket are not of the same

type, replace the socket.

Do not use extension leads or adapters.

After installation, make sure that the appliance is not standing on

the power supply cable.

Disconnect the appliance from the power supply by unplugging

it. Do not pull the power supply cable.

6gb33032.fm5 Page 24 Monday, May 23, 2005 2:17 PM

1 2 ... 27 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Smeg FA550X Mode d'emploi Page 32