Smeg FA550X Mode d'emploi télécharger pdf (Page 33)

LEVELLING YOUR REFRIGERATOR

The refrigerator has two front and two rear wheels at the

base of the product on each side that can be adjusted.

If the appliance seems unsteady or you want the doors to

close easier, adjust the appliance’s tilt following the

instructions below.

1. Check the installation location to be sure you have at least

1 cm clearance on all sides including the top.

2. Connect the appliance to the mains power supply.

3. Move the refrigerator into its final position.

4. Open both doors and remove the plinth to locate the

levelling bolts at the left and right of the refrigerator base.

The top bolt (1) will adjust the rear wheel, and the bottom

bolt (2) will adjust the front wheel.

5. Use the wrench provided to adjust the levelling bolts. Turn

the levelling bolt clockwise to raise the appliance, or anti-

clockwise to lower it.

It may take several turns of the levelling bolts to adjust the

tilt of the refrigerator.

Note:do not unscrew the levelling bolts too much when

lowering the appliance as they could fall out.

Aligning the doors

If, after switching on the appliance and adjusting the refrigerator

and freezer doors, the doors are misaligned, disconnect the

appliance from the power supply and adjust both doors as

indicated in the enclosed diagram.

6gb33032.fm5 Page 25 Monday, May 23, 2005 2:17 PM

1 2 ... 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Smeg FA550X Mode d'emploi Page 33