Smeg LSTA146S Manuel d'instructions télécharger pdf (Page 24)

11 Appliance does not spin

Anti-imbalance safety device tripped because laundry not evenly distrib-

uted in drum. If laundry is still wet at end of cycle, rearrange it in the drum

by hand and repeat spin programme only.

12 Emptying water from drum

In the event of a power blackout or appliance failure, the water can be

removed from the drum using the emergency procedure.

13 Laundry not properly spun

Large items screwed up and not evenly distributed within drum. Always

wash a mix of large and small items.

14 Traces of detergent on

laundry

Many phosphate-free detergents contain substances with low water solu-

bility.

Select Rinse programme or brush the laundry.

15 Laundry not dried

Check that:

- water tap is turned on

- load of laundry is not excessive

- drying time is long enough

- appropriate drying time selected.

If the appliance still does not dry the laundry, call the Service Centre to

have the fan and drying ducts cleaned to remove any fluff deposits.

16 Washing results unsatis-

factory

- Probably too little detergent or unsuitable detergent used

- Difficult stains not dealt with before washing

- Correct temperature not set

- Basket overloaded.

ERROR DISPLAY

In case of a malfunction, the appliance will identify the problem by showing an error code on the display.

Error code Key to problem

Door not properly closed. Try reclosing.

Aqua stop device tripped. Cut off power supply, turn off water tap and contact nearest

service centre.

Water not taken in for washing. See point 2 in troubleshooting table.

Water not pumped out. See point 4 in troubleshooting table.

For all the other error codes displayed, cut off the electricity supply, turn off the water tap and contact your nearest

Service Centre.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Pas de commentaire

Smeg LSTA146S Manuel d'instructions Page 24