Smeg LSTA146S Manuel d'instructions télécharger pdf (Page 28)

Place the template of the inner side of the panel and match the

height of the baseboard with the lower edge of the panel (fig. 4)

using the graduated scale. Make sure the template is horizon-

tally centred with reference to the vertical lines marked at the

ends.

After placing the template in the correct position, trace the posi-

tions of the following holes, pushing in with the tip of your pen-

cil:

• holes for the hinges and hinge screws (fig. 4)

•

holes for fixing the metal plate (if the magnetic lock is

used), or the hook for the push-pull lock (fig. 4, A - B)

Applying the

panel elements

and fixing the

panel

1) Drill the holes for the hinges (fig. 5), the hook for the push-

pull lock (fig. 5), or the metal plate if you decide to use the

magnetic lock (fig. 6), and the holes for fixing the hinges

(fig. 6).

2) The 13 mm depth of the 2 mm holes, for fixing the hinges

and a metal plate for the magnet lock, only applies to the

solid wood panel. For the chipboard panel, simply drill the

upper coating – fig. 6.

3) Screw the two hinges to the panel (fig. 7)

4) Mount the hook for the push-pull lock or the metal plate for

the magnet lock on the side opposite the hinges (fig. 7).

5) Fix the panel to the washing machine following the instruc-

tions shown in fig. 8.

Adjusting the

hinges

If, after applying the panel to the washing machine, it is slightly

inclined or off-centre with respect to the front of the machine,

correct its position by adjusting the mobile part of the hinges

(fig. 9).

Positioning the

washing ma-

chine in the

cabinet

Position the washing machine in the cabinet and, if necessary,

adjust the feet to level it and lock them with the relative locknut.

On appliances with adjustable rear feet, refer to the operator’s

manual.

To prevent the vibrations generated by the washing machine

from being transmitted to the cabinet, make sure the sides and

top do not touch the cabinet. There must be a gap of at least

2 mm. The back of the machine must also remain detached

from the rear panel.

If the cabinet is 870 mm high, the washing machine height-

ening kit on sale from the Spare Parts Service, must be

used.

To comply with safety legislation, any gaps between the floor

and the bottom of the baseplate and between the floor and the

sides of the machine when it is positioned at the end of a line of

furniture must be completely closed.

The cover must be installed in such a way as to make it

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34

Commentaires sur ces manuels

Pas de commentaire

Smeg LSTA146S Manuel d'instructions Page 28

Commentaires sur ces manuels