Smeg Integrated Washer WDI16BA Manuel d'utilisateur télécharger pdf (Page 21)

5.11 STARTING THE WASHING PROGRAMME

1. Bef ore starting the selected programme, carefully close the door, open the water tap and add the deter-

gent and additiv e

2. Press the “Start-Pause” button. The LED located above the Start-Pause button remains lit throughout the

cy cle.

After starting, the display shows the time remaining until the end of the programme. The LED remains on

throughout the cycle.

If delayed starting has been set (only f or models f eaturing this option), the display visualises the time remain-

ing bef ore the cycle starts. When delayed starting is set, the relativ e LED f lashes on and off.

5.12 INT ERRUPTING OR CHANGING THE WASHING PROGRAMME

The washing programme may be interrupted at any time while it is running:

1. press “Start/Pause” f or approximately 3 seconds: the display alternates between STOP (f or 1 second)

and three horizontal lines (f or 1 second) and the Start/Pause LED f lashes.

The programme can also be stopped by turning the programme/temperature selection knob while the cy -

cle is running.

2. If you wish to change the washing programme, simply select the new programme by turning the pro-

gramme knob without pausing the machine f irst. The new washing cycle will be perf ormed starting from

the beginning. If the tub is already full of water, the new programme will omit the filling phase.

3. To resume the cycle, press Start-Pause again.

5.13 END OF PROGRAMME

The washing programmes are automatically completed, the display shows END and the

“Time remaining” LED lights up.

1. Turn the programmes knob to OFF to switch off the machine.

2. Open the door.

3. Remov e the washing from the drum.

4. Leav e the door ajar in order to allow the inside of the washer dryer to dry.

5. Turn off the water tap.

If the no-spin option was selected during the initial spin speed set up phase and the machine stops with the tub f ull

(spin speed 0), STOP appears on the display at the end of the washing programme, alternating with 0000 (spin

speed 0) and the spin LED lights up.

Example

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

Pas de commentaire

Smeg Integrated Washer WDI16BA Manuel d'utilisateur Page 21